EUTECH INSTRUMENTS WP PCD 650 Instrukcja Obsługi Pobierz pdf (Strona 97)

Instruction Manual PCD 650

4.7.2 TDS Settings – Page 2

Figure 81 : TDS Settings - Page 2

This page allows you to set alarm limits for the TDS measurement mode:

Parameter Description Factory Default

Alarm Set

Points

Set alarm limits for the TDS measurement mode:

ENABLE – The measurement screen shows HI or LO

alarm indicators when the meter reading is above ‘HI

alarm value’ or below ‘LO alarm value’ specified in HI

& LO

ppm parameters (below)

DISABLE – HI and LO alarms are not shown in the

LCD

DISABLE

Hi ppm

Specify Hi alarm value here. The Hi alarm occurs

when the TDS reading goes above this value

Available range: Hi ppm to 2.00 ppm

(This parameter is not editable when ‘ALARM SET

POINT’ is disabled)

2.00 ppm

Lo ppt

Specify Lo alarm value here. The Lo alarm occurs

when the TDS reading goes below this value

Available range: 1.00 ppt to Hi ppm (specified above)

(This parameter is not editable when ‘ALARM SET

POINT’ is disabled)

1.00 ppt

) Press (Up) or (Down) arrow key to set high or low alarm point.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 119 120

Brak uwag

EUTECH INSTRUMENTS WP PCD 650 Instrukcja Obsługi Strona 97