EUTECH INSTRUMENTS WP PCD 650 Instrukcja Obsługi Pobierz pdf (Strona 88)

Instruction Manual PCD 650

4.2.5 System Settings – Page 5

This page allows you to enable password protection for the setup mode &

calibration mode.

Figure 72 : System Settings - Page 5

When you enable password protection, the meter prompts to enter the password

whenever you try to access the Setup or Calibration mode. (See Figure 67: Login

password screen).The meter does not allow you to edit setup parameters or perform

a new calibration unless you enter the correct password. If an incorrect password is

entered for 3 consecutive times, the meter goes to measurement mode.

Parameter Description Factory Default

Password

Protection

ENABLE – Sets password protection for the setup &

calibration mode. If this is enable you need to specify

a 5-digit password in the ‘SET PASSWORD’

parameter below

DISABLE – Disable password protection of the meter

DISABLE

Set Pass

Word

Specify your 5-digit password here. Use

(Up) &

(

Down) key to select a number and then press ENTER

key to confirm and move to the next digit.

Do not set your password to ‘00000’ as this is

reserved for ‘read-only’ password.

(This parameter is not editable when ‘PASSWORD

PROTECT’ is disabled)

88888

Confirm New

Password

YES – Select this if you have made changes to the

password and you wish to confirm the changes.

NO – Select this if you wish to ignore the changes

made to the password and to store the default

password.

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 119 120

Brak uwag

EUTECH INSTRUMENTS WP PCD 650 Instrukcja Obsługi Strona 88