EUTECH INSTRUMENTS WP PCD 650 Instrukcja Obsługi Pobierz pdf (Strona 20)

Instruction Manual PCD 650

6. Once the wizard completed the installation (Figure 13), click Finish to close

the wizard.

Figure 13 : ‘Found New Hardware Wizard’ completed

7. In CyberComm 600 application screen, click Find Device button. The

screen shows a message “Finding device”. When CyberComm recognizes

the meter it shows “Instrument in Range, click Connect button to establish

connection…”

8. Click Connect button. Once the connection is established, the

measurement data sent by the meter is shown in the CyberComm screen.

1.6.4 Connecting to the meter

Once you successfully established the connection between the meter and

CyberComm, for the first time, as described in the above section, the

subsequent connections will be established in a few easy steps.

Follow the steps below to connect CyberComm to the meter:

1. Start CyberComm by double-clicking on CyberComm 600 Desktop icon.

Make sure the IrDA port of the meter is closer and pointing towards (line-of-

sight with) the IrDA port (or USB-IrDA dongle) of the computer.

2. In the meter, press PRIN (F3) key. IrDA data communication icon

starts animating as the meter sends data to computer through IrDA.

3. In CyberComm, press Find Device button.

Note: If you do not see the above message, re-position the IrDA port of

the meter with IrDA port of computer so that they become close to each

other and are in-line.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 119 120

Brak uwag

EUTECH INSTRUMENTS WP PCD 650 Instrukcja Obsługi Strona 20