EUTECH INSTRUMENTS CYBERSCAN DO 1500 DO METER Instrukcja Obsługi Pobierz pdf (Strona 8)

Instruction Manual DO 300

3.2 Connecting the Probe

Your meter uses a dissolved oxygen/temperature probe. The probe cable has a notched 6-pin

connector to attach the probe to the meter.

NOTE: Do not substitute other probes. For a replacement probe, see the “Accessories”

section, page 47- 48.

NOTE: Keep connector dry and clean. Do not touch connector with soiled hands.

To connect the probe:

1. Line up the notch and 6 pins on the meter’s connector with the holes in the probe’s

connector. Push down and turn the locking ring to lock into place. See Figure 4 below.

2. To remove probe, unscrew the metal locking ring by turning the ring counterclockwise

and slide up the probe connector. While holding onto metal sleeve, pull probe away from

the meter.

CAUTION: Do not pull on the probe cord or the probe wires might disconnect.

Figure 4: Connect DO Probe

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 59 60

Brak uwag

EUTECH INSTRUMENTS CYBERSCAN DO 1500 DO METER Instrukcja Obsługi Strona 8