EUTECH INSTRUMENTS CON 700 - REV 2 Instrukcja Obsługi Pobierz pdf (Strona 14)

4) When the READY indicator appears, press to accept. The

t primary reading will flash briefly before returning to measuremen

mode upon successful calibration.

5.5 Manual Conductivity & TDS Calibration Procedure

1) Press

as needed to select conductivity (μS or mS) or TDS

(ppm or ppt) calibration.

2) Dip the electrode into the calibration standard and press

Provide stirring for best results.

The primary display will show the current reading,3) while the

secondary display will be the factory default value. Adjust the

conductivity or TDS reading using or . Press to

accept. The primary reading will flash briefly before returning to

measurement mode upon successful calibration.

5.6 Temperature Calibration

The thermistor sensor used for automatic temperature compensation

req mended upon probe

nt,

1) n with a known accurate temperature

e bath.

2) Press

and measurement is accurate and stable, so frequent calibration isn’t

uired. Temperature calibration is recom

replaceme whenever the temperature reading is suspect, or if

matching against a certified thermometer is desired.

Place the probe into a solutio

such as a constant temperatur

followed by . The primary display shows the

) Adjust the temperature using

measured temperature while the secondary display shows the

factory default temperature.

4 or . Press to accept or

n adjustable maximum value of ± 5

C to cancel. T

he meter allows a

( r ± 9 F) from the factory default temperature.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Brak uwag

EUTECH INSTRUMENTS CON 700 - REV 2 Instrukcja Obsługi Strona 14